Welcome to the Facial Oils and Oil Serums Course. This course teaches you to make three kinds of water-free leave-on products for the face: facial oils, oil serums and beard oils. It is built for hobby makers and small home businesses, and it starts from zero: no making experience is assumed. This first module sets out what these products are, where water draws the line, where the law draws the line between a cosmetic and a drug, and the workflow every product in the course follows.
What you'll learn
- LO1.1 Describe facial oils, oil serums and beard oils and distinguish them from emulsions and balms.
- LO1.2 Explain why water is the dividing line between this course's products and water-based serums.
- LO1.3 Classify these products as leave-on cosmetics and recognise the claims, ingredients and uses that take a product outside the cosmetic route or outside this course.
- LO1.4 Follow the course workflow: design on paper, check limits, make a small batch, observe, record, then label.
- LO1.5 Calculate the grams of each oil for one bottle from a percentage formula and a measured density.
Three products, one family
Facial oil. A blend of carrier oils (plant oils such as jojoba, rosehip or camellia), sometimes with squalane or a light ester, and sometimes a little essential oil. It is pressed or smoothed onto the face in a few drops.
Oil serum. Also water-free, but usually lighter in feel and carrying small amounts of oil-soluble additions such as tocopherol (vitamin E), bisabolol or a botanical CO2 extract. It is sold in small dropper or pump bottles. "Serum" has no legal definition; it describes a light, concentrated-feeling product. In this course the word always means a water-free oil serum.
Beard oil. A facial oil worked into a beard and the skin under it. IFRA's guidance groups beard and moustache care with facial moisturisers [S9], which tells you that a beard oil is a face product, with face-product limits.
How these differ from their cousins:
| Product | Water? | Structure | Where it is taught |
|---|---|---|---|
| Facial oil, oil serum, beard oil | None | Liquid blend of oils | This course |
| Lotions and creams | Mostly water | Emulsion: oil and water held together by an emulsifier | Lotions and Creams course [S56] |
| Water-based "serums", toners, mists | Mostly water | Water or gel | Lotions and Creams (this course covers recognition only, Module 11) |
| Balms, butters, lip balms | None | Oils solidified with waxes or butters | Lip Balms and Body Butters course |
Why the face is different
Module 4 goes into the detail; here is the short version.
- Thinner, weaker barrier. The outer layer of facial skin (the stratum corneum) is thinner, made of smaller layers of cells, than on the trunk and limbs, and its barrier function is relatively poor. Eyelid skin has the poorest barrier of all [S26].
- More absorption, possibly. The data are scarce, but they suggest that skin on the forehead absorbs substances more than most other sites [S27].
- Close to the eyes, and in the sun. A face product is applied centimetres from the eyes and to the skin most often exposed to sunlight, which matters for phototoxic essential oils (Modules 2 and 9).
So a face product deserves more care than a body product, even when it contains nothing but oils.
Water is the dividing line
The most important decision in this course is a simple one: no water. A blend of oils, squalane and an oil-soluble antioxidant gives microbes almost nothing to grow in, so the course's products need no preservative (Module 6 explains the reasoning and its limits). Add water, a hydrosol, aloe, a glycerite or fresh plant material and the product becomes a water-based product that needs a broad-spectrum preservative, pH control and a laboratory challenge test before sale: the whole method of the Lotions and Creams course.
Is it a cosmetic?
Leave-on. The Cosmetic Regulations define a leave-on product as a cosmetic intended to stay in prolonged contact with the skin, hair or mucous membranes [S6]. Every product in this course is leave-on, which brings stricter allergen-labelling thresholds than rinse-off products (0.001% rather than 0.01%) [S6].
What a cosmetic may do. Health Canada's guidance says a cosmetic may have only a negligible effect that is local and transient, without needing to be absorbed into the body to work; its example is a moisturiser hydrating the outer skin [S2]. A facial oil that softens skin and helps it feel smooth fits comfortably.
Where the line is. The product's classification depends on how it is represented, what it contains and how it acts [S2]. Some examples matter especially for serums:
- Acne treatments, skin lighteners and SPF products are not cosmetics [S3].
- Claims about cells, collagen, repairing damage, rosacea, or effects like a medical or surgical procedure are therapeutic, allowed only on authorized drugs and natural health products [S8][S2].
- Tretinoin (retinoic acid) is prohibited in cosmetics and is an inherent drug [S1][S5].
- Products represented for microneedling or other ways of helping absorption through the skin are not consistent with cosmetics [S5].
Module 10 covers all of this in depth. If you are unsure whether a product idea is a cosmetic at all, the free "Is my product a cosmetic?" Quick Check in Selling Handmade Cosmetics in Canada walks through the questions.
Out of scope, whatever the law allows. House rule 6 keeps some products out of this course for safety: anything for the eye area (the notification guide's "Eyes" area [S4]), products for children under three, products for broken, irritated or sunburned skin, products for skin-piercing devices, and products marketed for acne, rosacea or any other condition (Module 2).
Giving away counts. Under the Food and Drugs Act, "sell" includes distributing to anyone, whether or not you are paid [S41]. A bottle given to a friend outside your household is covered by the same rules as one you sell, and the course's house rules on testing and records apply to gifts outside your household too.
The course workflow
Every product in this course follows the same six steps. They are the backbone of the assignments.
- Design on paper. Choose oils for feel and stability (Modules 5 and 6), write the formula in percent by weight totalling 100.00% (Module 8).
- Check limits. Every essential oil against its IFRA conformity document (lower of Categories 3 and 5B), the Hotlist, house rule 5 and the 0.5% cap; every addition against its supplier's rate (Modules 7 and 9). The Formulation Worksheet records these checks.
- Make a small batch. Weigh, blend and fill under clean, dry conditions (Modules 3 and 12).
- Observe. Keep retained samples and run the Oxidation and Stability Log (Module 12).
- Record. Batch log, lot code, supplier lots, distribution (Modules 12 and 14).
- Label. INCI names, allergens, directions for safe use, honest claims (Module 14).
Notice where labelling comes: last. A label is a promise about what is in the bottle, so it is written only once the formula is checked, the batch is made and the records exist. And before any product leaves your household, house rule 11 adds a laboratory microbial count of the finished product (Module 12).
Your first calculation: one bottle
Formulas in this course are written in percent by weight, and you weigh every ingredient on a scale. Bottles, however, are sold by volume (a 30 mL dropper bottle). To get from one to the other you need the density of your blend: its mass per millilitre. You measure it yourself by weighing a known volume (Module 8 shows how), because blends differ.
Three makers, three starting points
The course follows fictional makers through its examples. Three of them show how differently people arrive at a first facial oil.
- Priya already sells soap and wants to add a facial oil to her market table. Her habits come from soap: 3% essential oil, citrus for brightness, a bigger batch the better. Modules 2 and 9 will change two of those habits (the 0.5% cap and the ban on expressed citrus), and Module 8 will confirm the third.
- Arjun makes beard oil for himself and friends and wants to sell it at a barbershop. His questions are about labels, allergens and whether a beard oil is "really" a face product. It is (IFRA groups beard care with facial moisturisers [S9]), and Module 14 covers his label.
- Elena has never made anything and wants a simple, unscented facial oil for herself and, later, for gifts. She will follow the workflow exactly, keep her batches personal until she has a laboratory microbial count, and remember that a gift outside her household counts as distribution [S41].
None of them needs exotic ingredients. A good first facial oil uses three to five stable, well-documented carrier oils, an antioxidant at the supplier's rate, and no essential oil. Feel and shelf life come from choosing the oils well (Modules 5 and 6), not from additions with impressive names.
What this course will not ask you to do
- No water-based serums, toners or mists (Module 11 teaches recognition and safety only).
- No retinoids, acids, vitamin C, lighteners, sunscreens or cannabinoids in any project (house rule 7, Module 10).
- No copied recipes. Every worked formula is course-original and checked in Python.
- No promises that a product is safe, gentle, "non-comedogenic", "hypoallergenic" or suitable for sensitive skin (Modules 5, 10 and 14).
- No legal, tax or medical advice. Regulatory summaries are general information; Selling Handmade Cosmetics in Canada gives the full rules.
Key terms
- Facial oil: a water-free blend of carrier oils, sometimes with squalane, esters or a little essential oil, for the face.
- Oil serum: in this course, a water-free, light-feeling oil blend with small oil-soluble additions.
- Beard oil: a facial oil for beards; a face product with face-product limits [S9].
- Carrier oil: a plant oil used as the base of a blend (as opposed to an essential oil).
- Emulsion: a mixture of oil and water held together by an emulsifier, such as a lotion or cream.
- Leave-on product: a cosmetic intended to stay in prolonged contact with skin, hair or mucous membranes [S6].
- Density: mass per unit volume (g/mL); used to convert a bottle's volume into grams.
- House rule: a course rule stricter than the law or standard it names.
Summary
- This course makes three water-free leave-on face products: facial oils, oil serums and beard oils. "Serum" here always means a water-free oil serum.
- Facial skin has a thinner, weaker barrier, eyelids most of all [S26]; absorption may be higher on the forehead [S27].
- Water is the dividing line (house rule 1): any water-containing ingredient moves a product to the Lotions and Creams rules.
- These products are leave-on cosmetics [S6]; a cosmetic may have only a negligible, local, transient effect [S2]. Acne, lightening and SPF products are not cosmetics [S3]; therapeutic claims are not allowed [S8]; tretinoin is prohibited [S1]; microneedling products are not cosmetics [S5].
- Giving away counts as selling [S41].
- Workflow: design, check limits, make a small batch, observe, record, label.
- One 30 mL bottle of formula A at 0.92 g/mL is 27.60 g; its tocopherol (under 0.20 g) is too small to weigh accurately alone, so batches are made larger.