Welcome to the Lotions and Creams Course. This first module explains what these products are, why they carry more risk than soap or balm, where the line sits between a cosmetic and a drug, which products this course leaves out on purpose, and the workflow you will follow for every formula. It ends with the first, simple calculation of the course.
This course is for adult hobbyists and small home-based makers. It assumes no making experience. Modules 1 to 3 are free, including Module 2, which you must pass at 100% before the hands-on modules open.
What you'll learn
- LO1.1 Describe body milks, lotions and creams as emulsions and place each on the spectrum from thin to thick.
- LO1.2 Explain why water makes these products vulnerable to microbial growth in a way that cured soap and water-free balms are not.
- LO1.3 Classify lotions and creams as leave-on cosmetics and recognise the claims and uses that take a product outside the cosmetic route or outside this course.
- LO1.4 Follow the course workflow: design, check limits, choose a preservative, make a small batch, measure pH, observe and test, record, then label.
- LO1.5 Calculate the grams of each phase in a small test batch from a percentage formula.
What an emulsion is
Oil and water do not mix. Shake them together and they separate again within seconds. An emulsion is a mixture in which one of them is broken into tiny droplets spread through the other, and held there by an emulsifier, an ingredient that sits at the boundary between oil and water. Almost every lotion and cream is an oil-in-water emulsion: droplets of oil spread through water. That is why a lotion feels light, rinses off with water and can be thinned with it. Module 4 explains the science properly; for now, three ideas are enough:
- the water phase holds water and everything that dissolves in it, such as glycerin;
- the oil phase holds oils, butters, fatty alcohols and the emulsifier;
- a few heat-sensitive ingredients, such as the preservative and fragrance, are often added during cooling as a cool-down phase.
Body milk, lotion and cream: one spectrum
Body milks, lotions and creams are the same kind of product at different points on a line. At the thin end is a pourable body milk with relatively little oil phase; in the middle, a lotion that flows from a pump; at the thick end, a cream that holds its shape in a jar. Moving along the line, the oil phase, waxes and thickeners increase and the product becomes richer and stiffer. Beyond the cream sits the balm, which has no water at all: it belongs to the course Lip Balms, Salves and Body Butters, not this one.
Health Canada's notification guide reflects the same spectrum. Its forms of product include "Semi-solid lotion" (a liquid emulsion thicker than a typical liquid; example, body lotion) and "Semi-solid cream" (a thick, creamy product with an emulsion-like consistency; example, hand cream), alongside "Semi-solid ointment/balm" for fatty products such as lip balm [S4].
Why water changes everything
Soap is caustic while it is being made, and cured soap is a hostile place for microbes. A balm contains no free water. A lotion is mostly water, at a skin-friendly pH, and it is used by dipping fingers into it or pumping it into damp hands. Health Canada says preservatives, natural or synthetic, are essential for all cosmetics, and that microbes can get in whenever a product or its applicator touches the skin and then goes back into the container [S3]. The EU's Scientific Committee on Consumer Safety describes contamination entering both during making and during use, from the moment a package is opened [S28].
Real recalls show what happens when this goes wrong. Health Canada has recalled a moisturizing lotion and a hand cream over possible Pseudomonas aeruginosa [S5], an anti-wrinkle cream that developed mould over time [S6], and a range of skin-care products, including a skin cream, over possible Burkholderia cepacia contamination [S7]. In a published hospital outbreak, a contaminated moisturizing body milk was the source of serious infections in five intensive-care patients [S17]. A contaminated lotion can look and smell normal. That single fact shapes this whole course: the microbial safety module is free and gated, and preservation, pH and testing run through every later module.
Lotions and creams are leave-on cosmetics
The Food and Drugs Act defines cosmetics broadly, and lotions and creams fit comfortably inside it. In Canadian rules they are leave-on products: the Cosmetic Regulations define a leave-on product as one intended to stay in prolonged contact with the skin, hair or mucous membranes [S31], and Health Canada's notification guide gives lotions and creams as examples [S4]. Leave-on status matters throughout this course:
- fragrance allergens must be named on the label above 0.001%, ten times lower than for rinse-off products like soap [S31];
- IFRA fragrance limits for leave-on products applied with the hands are far lower than for soap (Module 16);
- some Hotlist ingredients have leave-on conditions; methylisothiazolinone, a common preservative in rinse-off products, is not permitted in leave-on products at all [S1].
Where the line is
Claims that make a drug or natural health product
What you say about a lotion can change what it legally is. Health Canada looks at how a product is represented, what it contains and how deeply it acts [S54]. Therapeutic claims, those suggesting a product treats or prevents a disease or condition or modifies a body function, are allowed only on drugs and natural health products, which carry a DIN or NPN [S3]. A cream "for eczema", "for psoriasis", "for acne", "soothes rashes", "heals" or "relieves itching" is making a therapeutic claim. Health Canada's monograph for medicated skin care products shows the other side: claims about dry skin, such as "relieves/soothes dry skin" or "protects against chapping … due to dryness", are the non-therapeutic kind [S55]. Module 8 and Module 18 go into detail.
Products outside the cosmetic route
- Sunscreens. A product that claims sun protection is a drug or natural health product; sunscreens carry a DIN or an NPN on the label [S71].
- Cannabis products. Cannabis is prohibited in cosmetics; hemp seed oil and other exempt derivatives may be used only if they contain no isolated or concentrated phytocannabinoid [S1]. A "CBD cream" is outside the cosmetic route.
- Medicated or healing creams, including diaper rash, sunburn relief and acne products.
This course explains why these products are outside the cosmetic route and stops there. To check a product idea, use the free "Is my product a cosmetic?" Quick Check in Selling Handmade Cosmetics in Canada.
Products outside this course
Anhydrous products (balms, butters and lotion bars) are also outside this course, because they belong to the lip balm and body butter course.
The course workflow
Every formula in this course follows the same eight steps, in order:
- Design on paper. Write the formula in percentages, phase by phase (Module 13).
- Check every limit. Hotlist conditions, IFRA limits, allergen thresholds and claims (Modules 8, 16 and 18).
- Choose the preservative. A manufacturer's broad-spectrum system used inside its stated range and pH window (Modules 2 and 9).
- Make a small batch. Clean, sanitised equipment, distilled water, careful temperatures (Modules 3 and 14).
- Measure the pH. A calibrated meter, a recorded method, adjustment if needed (Module 10).
- Observe and test. Retained samples, a stability programme, and a laboratory challenge test of the final formula in its final package (Modules 11 and 12).
- Record. A lot code and a file for every batch (Module 18).
- Only then label and sell. Honest labels, cosmetic claims only (Module 18).
How the course is organised
The course has 18 modules in six sections, and takes about 32 hours:
- Foundations (Modules 1 to 3, free): this module, microbial safety and preservation, and the workspace.
- Emulsion science (Modules 4 and 5): how emulsions form and fail, and how emulsifiers work.
- Ingredients (Modules 6 to 8): oils and emollients, the water phase, and actives within cosmetic limits.
- Preservation and quality (Modules 9 to 12): preservative systems, pH, challenge testing and stability.
- Making (Modules 13 to 16): formulating, batch day, packaging and fragrance.
- Fixing, records and selling (Modules 17 and 18): troubleshooting, records, labels and claims.
Each module has a quiz drawn from a bank of questions; you need 80% to pass, with unlimited retakes, except Module 2, which needs 100%. Each section ends with a section test, and there is a final exam. Four practical assignments (a formulation worksheet, a batch log, a stability log and a label check) are self-assessed against detailed checklists and model answers; no one reviews your work. Completing everything earns a Certificate of Completion from Island Enchantments, which records that you finished the course; it says nothing about the safety of any product you make.
Your first calculation
Lotion formulas are written as percentages by weight, adding up to exactly 100%. To make a batch, you convert each percentage to grams. Module 13 teaches formulating in full; here is the idea.
The table below is a teaching example written for this course. It has not been tested and is not to be made for sale or gift; any formula you make needs its own stability and challenge tests.
| Phase | Ingredient (role) | % |
|---|---|---|
| A (water) | Distilled water | 70.50 |
| A | Glycerin (humectant) | 3.00 |
| A | Xanthan gum (thickener) | 0.30 |
| B (oil) | Sunflower seed oil (emollient) | 14.00 |
| B | Shea butter (emollient) | 4.20 |
| B | Emulsifying wax system (emulsifier) | 6.50 |
| C (cool-down) | Preservative, System 1 (Module 9) | 1.00 |
| C | Tocopherol (antioxidant for the oils) | 0.50 |
| Total | 100.00 |
The preservative in that batch is 200 × 1.00 ÷ 100 = 2.00 g, which is why Module 3 insists on a scale that reads to 0.01 g.
Key terms
- Emulsion: a mixture of oil and water in which one is dispersed as droplets in the other, stabilised by an emulsifier.
- Oil-in-water emulsion: oil droplets dispersed in water; the usual structure of lotions and creams.
- Phase: a group of ingredients prepared together (water phase, oil phase, cool-down phase).
- Leave-on product: a cosmetic intended to stay in prolonged contact with the skin.
- Therapeutic claim: a claim to treat, prevent or cure a disease or condition, or to modify a body function; not allowed on a cosmetic.
- Teaching example: a course-original formula used to explain a method, not a tested product.
Summary
Body milks, lotions and creams are oil-in-water emulsions on one spectrum from thin to thick; balms, which contain no water, belong to another course. Water makes these products vulnerable to microbes in a way soap and balms are not, and contaminated lotions have caused recalls and serious infections. Lotions and creams are leave-on cosmetics, which brings lower allergen thresholds, lower fragrance limits and leave-on Hotlist conditions. Therapeutic claims, sunscreens, cannabis products and medicated creams fall outside the cosmetic route, and products for the eye area, children under three and broken skin are outside this course. Every formula follows the same workflow, from design to labelling, and starts as percentages that add up to exactly 100%.